Technical features
FIPRO SG 589 is a highly efficient alkaline degreaser for pre-treatment cycles on steel. It can be used by immersion or spray on steel and stainless steel.
Usage and Applications
FIPRO SG 589 is used in aqueous solution, by spray or by immersion.
Operating conditions vary depending on how they are used, as described below.
Spray immersion
Bath temperature: 60 ÷ 80 ° C 40 ÷ 70 ° C
Treatment time: 5 ÷ 20 '2 ÷ 10'
Pressure: 1 ÷ 3 bar
Formation: 100 ÷ 200 g / l 20 ÷ 100 g / l
Score: 52 ÷ 104 ml 10.4 ÷ 52 ml
Physical-Chemical Data
Parametro | Valore |
|---|---|
Appearance | Colorless liquid |
Density | ~1.4 Kg/l |
Viscosity (DIN 53211, 4 mm cup, 20 °C) | 19 second |
Surface tension (10 g/l, 20 °C) | ~68 mN/m |
Stability | da - 7 °C a + 40 °C |
Conductivity (10 g/l, 20 °C) | 13.3 mS/cm |
Control of bathing
Take 10 ml of bath, pour them into a conical flask, add about 50 ml of demineralized water and 3 ÷ 5 drops of phenolphthalein indicator, titrate with 0.1 N sulfuric acid until the color changes from pink to colorless. The ml of acid consumed for the color change represents the degreaser score.
A bath prepared at a concentration of 20 g / l will have a score of 10.4 ml.
Applicazione | Concentrazione |
|---|
Alimentation
The bath must be maintained at the score set at the time of system start-up by adding FIPRO SG 589 at a rate of 1.9 kg for each missing point and for each 1000 l of solution and 0.25 g / l of additive.
Tanks and Storage
All the parts in contact with FIPRO SG 589 can be built with chromium nickel, AISI 321 or chromium nickel molybdenum, AISI 316Ti steel.
For the transport, storage, handling and discharge of wastewater, follow the indications and laws in force. For further information on the product consult the Safety Data Sheet.
Store the product in its original sealed packaging in a cool place away from frost and direct sunlight.
Highlights
Multi-material degreasers
Pre and Post processing treatments
Low environmental impact alternatives
Longevity and effectiveness
Periodic checks
Formulated, produced and controlled internally
Application
Removal of whole and emulsifiable oils, fats and processing pastes
Dephosphating
Removal of polishing pastes from parts and small parts
Removal of interoperational, protective, polymer films and silicones
Etching, pre-painting, pre-conversion treatments
Cleaning of plastics and glass
Interoperational or final cleaning of the product
UN PO' DI NOI
